Lenze PLC Designer PLC Designer (R3-1) - Manual (Page 241)

L-force | PLC Designer
Menu Commands sorted by Categories

DMS 4.1 EN 03/2011 TD29 239
12.7 CFC
The command category 'CFC' provides commands for working in the CFC Editor.
12.7.1 CFC Editor commands
The commands of category 'CFC' are provided by the 'CFC Editor' plug-in and are
available for programming in the CFC editor.
By default they are part of the "CFC" menu. If necessary, open the Customize dialog,
category 'Menu', to view or modify the current menu configuration.
The commands:
• Edit Working Sheet
• Negate
• EN/ENO
• Set/Reset:
− None
− R - Reset
− S - Set
• Execution Order:
− Send To Front
− Send To Back
− Move Up
− Move Down
− Order By Data Flow
− Order By Topology
− Set Execution Order
• Connect Selected Pins
• Reset Pins
• Remove unused pins
• Edit Parameters...
12.7.2 Edit Working Sheet
This command (category CFC) opens the Edit Working Sheet dialog for modifying the
size of the working area ("working sheet") of the current CFC.
The size of the "working sheet" is defined by the height and width of a rectangular
area having its origin (X: 0, Y: 0) in the upper left corner of the editor window and
including all existing CFC elements. Height and width are specified in number of grid
units whereby the size of a grid unit is not changeable by the user. Height (Y):
increasing positive values from top to down, width (X): increasing positive values from
left to right.
The maximum size is 2048 grid units in width and height.