Lenze PLC Designer PLC Designer (R3-1) - Manual (Page 462)

L-force | PLC Designer
Menu Commands sorted by Categories
460 DMS 4.1 EN 03/2011 TD29

The current configuration will be stored as default for the project. If currently all
project objects are selected, then later by default always all objects, that is also any
newly created, will be selected. If in the current settings some objects are excluded
from selection, then by default exactly the remaining selection will be set and thus
newly created objects not be selected.
12.24.3 Page Setup...
Symbol:
This command (category 'Print') opens the Page Setup dialog for configuring the layout
of a printout page which can be produced via the 'Print...' or 'Document...' command.
Button Preview always is available to check the currently configured page setup in a
preview. The dialog 'Seitenansicht' will open where you can browse through the
configured pages.
Abb. 239 Dialog 'Page Setup', Preview'