Lenze PLC Designer PLC Designer (R3-1) - Manual (Page 878)

L-force | PLC Designer
Device Editors
876 DMS 4.1 EN 03/2011 TD29

CANbus Configuration
This configuration dialog for the CANbus node is currently without function, because
the device description - with exception of the baud rate and net number - is not
providing any further configuration parameters.
Status
This tab of the configuration editor for an CANbus device or module provides status
information (for example "Running", "Stopped") and device-specific diagnostic
messages, also on the used card and the internal bus system.
Information
This dialog in the CANopen device or module configuration shows information on the
device resp. module which is currently selected in the devices tree. If available for the
current module, the following general information will be displayed: Name, Vendor,
Type, Version number, Categories, Order Number, Description, Image.
CANopen Manager
The CANopen Manager is an obligatory node below the CANbus node in a CANbus
configuration. It is supporting the CANbus configuration by internal functions, thus
usually serving as the CANbus master.
Abb. 481 CANopen Manager dialog
In the CANopen Manager dialog you can enable the synchronized transmission mode
for the PDO transfer on the bus and set some default values, which might be adapted
to the special use case in the Common.CANbus Configuration: